Analysis on Three Matters of Safe Use of Trowel

The trowel is also known as a light receiver, and its main structure is a gasoline engine driven spatula rotor, in the middle of the rotor on the bottom of the cross with a spatula. The direction of the spatula is the same as that of the rotor, and the trigger is rotated by the gasoline engine. Operation, the first hit the fire, hold the joystick, the two forward together is to move forward, with the pull back is moving back. An average of 100 to 300m2 per hour, compared with artificial wiping can improve work efficiency more than 30 times.

It is a concrete surface rough, fine trowel machine. The surface of the machine is more smooth and smoother than the surface of the artificial construction. It can greatly improve the compactness and wear resistance of the concrete surface, and improve the working efficiency by more than 10 times more than the efficiency. Ground trowels can be widely used in high standard plant, warehouse, parking lot, square, airport and frame building concrete surface of the pulp, smoothing, wiping. Is the preferred tool for concrete construction.
Equipment Exhibition
gasoline type ride-on concrete trowel
Instructions:
1, start the trowel, handle the handle
2, grip the joystick, so that the body to maintain balance
3, trowel machine work, we must help stabilize the wiping machine, in the floor on the time to adjust the direction of operation, so that the machine lost control
4, the first rough grinding, after grinding fine. After the bottom of the grinding mill, such as ground
Suitable for grinding to remove the disc, with a spatula fine grinding
Smearing machine safety precautions:
1. During construction, pay attention to the temperature of the motor gearbox can not exceed 80 degrees
2. Turbine tank oil must always check the oil standard, such as lower than the oil standard, please refuel. After each use should be promptly clean up the machine, especially the smear to be stored in a clean and dry and no corrosion in the environment. Punch worn to unilateral 30mm when the nut will be released, the wipes U-turn the screw can be tightened to achieve the purpose of the two pairs. Punch angle Turn the hand wheel to adjust the angle of the dice to achieve the desired effect. If you need to shut down in the construction, please turn off the power. When the gasoline engine shut down in time to press the handle on the switch to stop.
Wearable pieces of discs. Gasoline wiping valve valve pulling the top is because the valve duct wear and tear caused a serious gap between the valve stem and the catheter is too large, and then there is a high temperature caused by valve breakage.
3. In addition, we must always maintain the trowel, different season with different lubricants, the only way to ensure that the machine for a long time for us to work.

DOAN PAVEMENT MAONTENANCE EQUIPMENTS LIST